![]() The next step is to add a serial port to the Parallels Windows 2000 virtual machine configuration. To do this, install the Keyspan driver, version 2.3 or later under Mac OS X. The Keyspan USA-19HS serial to USB adapter works fine as long as it is set up properly. OOOOOORRRRR.when the guest machine starts up.(make sure that usb is enabled of course) go to VM-Devices-USB and select the usb to serial adapter to connect to the virtual machine.The VM should recognize that a new device has been plugged in and prompt you to install the driver which you will now do using the driver appropriate for the GUEST o/s.Using this option.your usb to serial will be assigned to a different com port than 1.usually 3 or something like that.Check the hardware config in the guest o/s after the install to see what com port was assigned to it then use that port number when connecting an RS232 or 485 device to your serial cable.Īnyway.hope this keyspan usb to serial adapter is SKETCHY at best with parallels. Go to your settings for the guest machine and add a serial port and use physical serial port and select the com port that the Host assigned to the usb to serial device.This option will always make the serial port on the guest machine be assigned to Com 1.so when you connect to your rs232 device via the serial port, select Com 1 in the guest o/s. If your Host is Mac.then insert the usb to serial adapter and install the Mac driver (If the HOST is XP then do the same except use the XP driver).then check to make sure it WORKS in the HOST(Very Important step).Then you can do one of two things.Either. ![]() You have to install the driver for the host o/s.Once you do that then you can transfer to the guest. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |